adding loop-thru jacks to the D11

[subspace]

I realize I can jumper J1 and J2 together to use the second jack as a loop-thru to an amp, but I'd like to retain use of both channels as independent DIs. Would adding TS jacks to the next set of holes in the CH01 wired in parallel to the D11 jacks affect it's performance in any way? Would the input impedence switch still be at the same value with an amp connected to the loop-thru?
I'm looking for a pair of super clean DIs to capture bass and guitar for later reamping and thinking these combined with T15s would fit the bill.
Thanks!

[tpryan]

Would adding TS jacks to the next set of holes in the CH01 wired in parallel to the D11 jacks affect it's performance in any way?

Should work fine, but we haven't tried it.

Would the input impedance switch still be at the same value with an amp connected to the loop-thru?

No, the total load on the instrument will be the amp and DI in parallel.

[simondolanbass]

Hu
I want to have know if it worked?
I want to use my d11 like this too

Thank
Simon