A12 Few questions...

[room4studios]

In the assembly instructions i couldn't figure out what step 33 meant:

"Connect the PS03 to J3. Simply wire the power supply connectors together in a 1:1
fashion. That is, PS03 J2, pin 1 to A12 J7 J3, pin 1, pin 2 to pin 2, etc"

Also when I was opening up the output transformer it had a lose piece that seemed to have come of the area on the side that the screw goes through. It doesn't seem critical but i thought it was best to mention it.

Cheers

Phil

[tpryan]

In the assembly instructions i couldn't figure out what step 33 meant

If you're making your own wiring harness, wire the connectors together in a 1:1 fashion. If you're using the WH01 wiring harness, just attach the connectors so the ramps interlock.

Also when I was opening up the output transformer it had a lose piece that seemed to have come of the area on the side that the screw goes through.

That's an extra "I" lamination that you can use to level the transformer.

[room4studios]

Thanks for your help Tim.

On a different topic, i also bought some J99's but didn't realise i need 2 opamps per preamp so have half the number of opamps that i require.

I sent a message to the sales email address a couple of days ago but haven't received any response, is there some other email i should be using?