Hello All. I've been searching around but just cant figure out whats wrong so I am afraid I need to start another one of these threads...
I turned R39 all the way CCW until I heard slight clicking on rotation, powered it all up according to the instructions, kept my finger on R40 while doing the preliminary tests and it never even got warm..
Then I started doing the adjustment on R39 to get the Transistor Case for Q6 to 22.2V. I was successful but then I noticed R40 was BLAZING hot. Instant burn when I touched it.
I have since moved my POS probe from the transistor case to the "Connector-Side" of the resistor and adjusted R39 until I read 4.8V as I read to do in other threads.
Now it doesnt burn my finger instantly, only after 2 seconds.
Is this normal operation?
I have N72 Revision 3.0