think I have a dud SC25 *solved*

[roy]

Hi,

I have just built a pair of A12s with a pair of SC25s.
One of the SC25s is non-functional.
It doesn't pass signal, the 'south' side of it gets very hot over about a minute after powering up and I measure 5.6VDC between pins 4 and 6.
It behaves like this in either A12.

The other SC25 works fine in either A12.

Should I send it in?
Or perhaps I can open it up and replace something inside?
I'm OK with a soldering iron, I've made two N72s and two C84s without a hitch.

cheers,
Roy

[roy]

Bump.

[tpryan]

You need to request an rma by e-mail.

[roy]

sent the SC25 back. Tim sent me a new one. A12 works fine now.

Thank you.
Roy

[Tajmoben]

I have exactly the same problem......built 4 and the problem follows the SC25. What do I need to do to get an RMA????