Blinking LED

[Delicieuxz]

I've just finished both an A12 and N72 module, which were both showing perfect voltage readings when tested seperately, and the chasis LED was at a steady ON when only 1 module was hooked up at a time.

Then I put both modules into the chasis, hooked them up to the PS, and now the LED only blinks, about once every 2 seconds.


Any ideas?

[tpryan]

Have you tried connecting only one module at a time while installed in the chassis? Is one of the modules in the left-most position? If so, are you sure there are no shorts against the chassis divider due to improperly trimmed component leads?

[Delicieuxz]

That was it! Thanks, now the light it working fine.
I've got to get another XLR cable tomorrow before I can try it out, but so far things are looking good for my first electronics project.