I think i may be missing some parts

[charlie_vela]

I just got my A12 in the mail (i'm excited to say the least). As i began to populate the board i noiced that i only have one three-pin header. I have a two and a four pin as well... is this right? On the Bill of Materials it says i should have two three pin headers. I also noticed that C1 was labeled 220 J COG 100 instead of COJ 50.... are these interchangeable?

Thanks a lot.
-Charlie

PS. In a totally unrelated question: I've been using 63-37 solder, but it's .05 diameter. I also have some 62/36/2 lying around thats .022 diameter. Would there be any problem with using that instead, since it'd probably be neater and easier to work with?

[charlie_vela]

nevermind... figured it out.. everything seems to be working fine. I'm going to get into testing it tomorrow. I'm really excited.

[tpryan]

If you think you're missing some components, please send the details directly to sales@seventhcircleaudio.com

You'll have a much easier time with small diameter solder.