CH01 - B16 Panel Template

[jmettam]

Hi All,

I have built 4x B16s and they are going into a CH01 chassis, so.... I decided to try printing out proper panel markings on a piece of printable plastic.

First run was done on Vinyl but I found it too stretchy and the ink scratched off VERY easily. Round 2 was printed on something less stretchy (I don't recall the material at the moment) and I put a clear layer on top. It does not stick down hard but the control nuts hold everything in place. All in all I think it will work well!

I will attache a picture and a PDF of the template (if I can get phpBB to cooperate!) for anyone who might find this usefull!

Thanks John

[jmettam]

Hmm, looks like PDFs aren't allowed!

PM me with an email address if you want me to send you the PDF.

John

[jmettam]

Here is a smaller image