So I got my A12 w/ chasis and power supply a few days ago and built the A12 yesterday. The power supply and chasis were already built and installed much to my delight.
At the testing phase of the A12 assembly, I installed the power switch and attached the harness. I plugged the cord into the wall, threw the power switch up, and nothing happened. No lights, no hum, nothing.
This is my first SCA endeavor - is there something I didn't do with the PS03? I assumed the only thing I had to do was connect the switch and voila. I tried flipping the 4-pin connector the other way around (holes downward) and all that did was snap off the plastic tooth on the bottom!
Any help would be much appreciated!
Cheers,
Andrew