PS03 - No Power

[apeebles]

So I got my A12 w/ chasis and power supply a few days ago and built the A12 yesterday. The power supply and chasis were already built and installed much to my delight.

At the testing phase of the A12 assembly, I installed the power switch and attached the harness. I plugged the cord into the wall, threw the power switch up, and nothing happened. No lights, no hum, nothing.

This is my first SCA endeavor - is there something I didn't do with the PS03? I assumed the only thing I had to do was connect the switch and voila. I tried flipping the 4-pin connector the other way around (holes downward) and all that did was snap off the plastic tooth on the bottom!

Any help would be much appreciated!

Cheers,

Andrew

[apeebles]

Weird. So, I came home today from work, disconnected and reconnected the 4pin plug, plugged the PS03 into the wall and ta da! It powered up!

The only other thing I did was connect the clamp-on ferrite to the AC line cord but I can't see that making any difference.

Oh well! It works and I'm happy.

Andrew