Older PS01, N72, and harness

Post questions or comments about the CH02 and OneShot here.

Older PS01, N72, and harness

Postby willie » Sun Jul 20, 2008 9:38 am

Ok, its an older kit I am just now finishing. I cant find instructions on the DPDT switch wiring, I did mine like the photo in the CH01...is that going to work for me? Where does that connect to the PS01? I see two 4 pin connectors toward the back of the PS01 where the mains connect...do I connect to the top or bottom one?

Also, I wanted to verify that if you put both 6 pin molex connectors side by side, same side up, pin one of the left molex wires to pin one of the right molex. I hope I explained this well enough!

Thanks very much!
willie
 
Posts: 1
Joined: Sun Jul 20, 2008 9:16 am

Return to Chassis and Power Supplies

Who is online

Users browsing this forum: No registered users and 12 guests

cron