Phantom question
5 posts
• Page 1 of 1
Phantom question
by pH » Thu Jan 24, 2008 10:58 am
Looking at the schematics for the A12 and the N72 I see slight differences in the schematic for phantom power. Wondering why these would differ...
- pH
- Posts: 4
- Joined: Tue Jan 22, 2008 6:26 pm
by tpryan » Thu Jan 24, 2008 12:33 pm
A12, C84, and T15 have emitter follower buffered slow-rise phantom circuits. N72 and J99 have two-stage RC circuits. Future revisions of N72 and J99 will have the same active circuits added, but we can't say when that will happen.
- tpryan
- Site Admin
- Posts: 2078
- Joined: Thu Dec 04, 2003 11:32 pm
by pH » Fri Jan 25, 2008 10:28 am
I'm looking at an older version of the A12 schematic from when I built it (about a year ago?). Schematic shows 48v from pin 5 through a 150 ohm resistor, across 220uf and .1uf caps to the xlr 6k6 resistors. Is there a diode missing on the schematic?
BTW, it's working fine, I'm just trying to better understand the dots I've connected
BTW, it's working fine, I'm just trying to better understand the dots I've connected
- pH
- Posts: 4
- Joined: Tue Jan 22, 2008 6:26 pm
by dkatz42 » Mon Jan 28, 2008 2:08 pm
tpryan \$m[1]:The protection diode wasn't added until we realized some people preferred to connect their power supplies backwards.
Guilty as charred, er, charged.
The good news was that the protection diodes on the expensive bits did their job.
- dkatz42
- Posts: 138
- Joined: Sat Sep 04, 2004 1:11 pm
5 posts
• Page 1 of 1
Return to Chassis and Power Supplies
Who is online
Users browsing this forum: No registered users and 7 guests