How to wire a rotary sswitch???

[3nity]

Ok i have a small rack 6 inches deep....was thinking about just turn around the board, put a rotary switch and panel mounts togles....is that feasable????

[dkatz42]

It's potentially feasible, but you'd have to find a compatible rotary switch with solder lugs (I don't think you want to try to tack a zillion little wires onto the ends of those PCB lugs on the supplied switch) and there would be a lot of wires. The signal going to/from the switch is extremely low-level, so you may have noise and hum issues as well.

Sounds like it's not worth the trouble, assuming that it would work acceptably when you were done (which may not be the case.)