Impedance Selection?

[Ken Schumacher]

The C84 specifications indicate you can select different impedances using a jumper. How is this done? I sometimes need to passively split a mic to two pres (location recording) and have been told the mics should see at least 5x impedance to meet their spec.

[tpryan]

The specifications pages for all the modules are temporary place holders at this time. The C84 has a fixed input impedance of 1500 ohms. Two paralleled 1500 ohm loads is a 750 ohm load, which is exactly 5x the output impedance of a 150 ohm mic.