The heat sinks touch two diodes and a capacitor when they rest on the "shoulders' of the regulator pins. I am guessing I should solder them a little higher to clear the other components. Correct?
Thanks for any help.
Heat Sink Clearance?
2 posts
• Page 1 of 1
Heat Sink Clearance?
by Ken Schumacher » Tue Sep 19, 2006 8:54 pm
- Ken Schumacher
- Posts: 37
- Joined: Sun Aug 27, 2006 10:47 am
- Location: Grass Valley, California
Heat Sink Clearance?
by Ken Schumacher » Thu Sep 28, 2006 5:00 pm
I decided to solder the heat sinks in place above the other parts so they weren't touching. Seemed to work OK.
- Ken Schumacher
- Posts: 37
- Joined: Sun Aug 27, 2006 10:47 am
- Location: Grass Valley, California
2 posts
• Page 1 of 1
Who is online
Users browsing this forum: No registered users and 10 guests