Finished first A12

[9volt dolt]

Hi, Just finished my first A12 and everything is fine, sounds awesome.

I adjusted R16 without changing the gain (i know tim recommends gain set to 6 or 7 or whatever setting you use most). I got mine down to 0.00-0.01 volts. Should I go back and reset it on a known gain setting or will it be ok the way I did it? R25 and R29 were set to about 18 volts for use with SC25.

Thanks a lot! I am recommending these to everyone I know who records.

[9volt dolt]

ok, i'm just going to run it as is (since it sounds fine).

if there is any reason to recalibrate it (damage to equipment?) please let me know.

thanks!

[tpryan]

There will always be drift and some small DC offset, no matter what. If you want to minimize it, adjust offset at your most commonly used gain setting when the unit is up to temperature.