Connecting power to a12 with alt PS

[AudioguyII]

Hi,
I would like to connect my neve PSU to the A12 to test it, it is a Power One HA24, I would like to know to which pins on the A12 connector J7 I need to connect my leads to. And which ones.
Thank you for your help.

Also... as stated in the instuctions, I tested pins 1 and 2 and also pins 2 and 3 to see if there was a short, well I get no reading at all. as if circuit is completely open, Is that okay?

Once again,
Thanks

[Category 5]

The A12 requires a bi-polar power supply design while the Neve uses a single positive voltage design. I am unfamiliar with the power supply you mention, but it is my belief that there is no way to properly use this supply for your intended purpose.

[AudioguyII]

Thanks for the help, when you say bipolar, do you mean 30V and 48 V for phantom? I was just trying to use it without phantom power for now...

[dkatz42]

Thanks for the help, when you say bipolar, do you mean 30V and 48 V for phantom? I was just trying to use it without phantom power for now...

Nope, the SCA pres require both a positive and a negative supply (+30V and -30V) as well as the +48 for phantom power. Take a look at the PS03 specs for more info.

[AudioguyII]

Thanks, I guess it's time just to get the PS03.
Thanks for the help!!!

Best.