Seventh Circle Audio

Posted: **Sun Jul 23, 2006 8:46 am**

Just wondering how to set jumpers J6, J8.

Thanks.

Posted: **Mon Jul 24, 2006 12:32 pm**

Jumper the "inner" pairs on each jumper. You can install the headers and use a shorting jumper, just solder in a bit of wire for a permanent connection.

Posted: **Mon Jul 24, 2006 2:34 pm**

Sorry Tim, can you explain a little more? Each header has three pins - what do you mean by the inner pairs? Do you mean you can use a bit of wire instead of the shorting jumpers?

Posted: **Tue Jul 25, 2006 8:42 am**

Find the pin on each header that is connected to PGND, which you can easily probe at J7, pin 2. You'll find these are the "outside" pins, farthest from each other, and indicated by a small "ADJ" on the silkscreen. Jumper the two "inside" pins on each header.

Posted: **Tue Jul 25, 2006 10:13 am**

So I would jumper pins 2 and 3 on J6, and pins 1 and 2 on J8?
(...figuring the pins are numbered left to right)

This is obviously part of the revision. Can you tell me what this is for? (Just curious.)

Thanks so much for the great pres and help.

Posted: **Tue Aug 08, 2006 4:41 pm**

So I would jumper pins 2 and 3 on J6, and pins 1 and 2 on J8?
(...figuring the pins are numbered left to right)

Correct.

This is obviously part of the revision. Can you tell me what this is for? (Just curious.)

Updated instructions will be up soon.

Seventh Circle Audio

J6 J8 jumper settings

J6 J8 jumper settings