Page 1 of 1
No Sound
Posted:
Wed Nov 30, 2005 8:00 pmby Nu-tra
I set the voltage at +-20 and all was well... I plugged a mic in and I'm getting no sound out of the ouputs on both J99's I've built... I have 6 A12's and channels 7 and 8 are J99's I'm sure I have the P3 power supply... any suggestions?
V
Posted:
Wed Nov 30, 2005 8:11 pmby Nu-tra
I guess I didn't solder jumpers for L1 and L2... What should use?
Posted:
Wed Nov 30, 2005 10:54 pmby Nu-tra
Screw it! I used some spare transformer wire and all is cherry... I can say I am finally done! Thank for all your support through 8 channels of fun!
V
Posted:
Thu Dec 01, 2005 4:11 amby tele_player
The kits include two 0 ohm resistors for this purpose, but wire works perfectly.
Posted:
Thu Dec 01, 2005 7:47 amby Nu-tra
I bought two kits and no zero ohm resistors... Will there be a sound difference?
Posted:
Thu Dec 01, 2005 8:49 amby tele_player
Absolutely no difference.