Seventh Circle Audio

Hi everyone

I bought the j99 kit a few weeks back and I am almost done with everything. I have been going pretty slow, just about 1/2 hour after work everyday. But I have one question about the input impedance of this preamp? I will be using this with a Rode NTK and the output is 200ohms. Now I think I read correctly where the input imp. on the j99 is 1200ohms.
Now is that going to jive well with this mic? Also , there is a jumper for the optimal impedances and its between 100/50. Does that mean the NTK with its 200 ohm imp. going to be a little off from that?

Im sorry if this is a stupid question

The NTK works perfectly with the J99. I think the optimal input impedance for the NTK "is" 1200 ohms, so there is nothing to be concerned about. That mic is particularly sweet sounding when used with this preamp.

Shane

thanks Cat 5

that makes me feel much better