Necessary to use Thermal Grease and Isolator Pad?

Post questions or comments about the N72 here.

Necessary to use Thermal Grease and Isolator Pad?

Postby Phrazemaster » Sun Jan 29, 2012 12:45 am

Hi, I noticed on the build you don't specify using a pad on the transistor and regulator, nor thermal grease.

My understanding was you are always supposed to use these as the regulator backing is not grounded and could cause a short. In fact in another DIY project I did, I damaged my power supply when I failed to use the pad and grease.

So, am I right in assuming that you have designed these boards NOT to need the grease or isolation pads on the regulators and large transistor?

Thanks,

Mike
Phrazemaster
 
Posts: 35
Joined: Wed Dec 20, 2006 2:09 pm

Postby tpryan » Mon Jan 30, 2012 1:19 pm

No pad or grease necessary. Just make sure the heat sink does not contact the chassis when you install the module.
tpryan
Site Admin
 
Posts: 2078
Joined: Thu Dec 04, 2003 11:32 pm

Postby Phrazemaster » Mon Jan 30, 2012 4:51 pm

Perfect; I figured you wouldn't have just forgotten something so vital.

I'm taking the extra time to install pads and grease, because I feel it will help heat transfer/reduce potential problems and extend the life of these amazing preamps.

Thanks,

Mike
Phrazemaster
 
Posts: 35
Joined: Wed Dec 20, 2006 2:09 pm


Return to N72

Who is online

Users browsing this forum: No registered users and 16 guests

cron