Just finished checking J1 N72?
3 posts
• Page 1 of 1
Just finished checking J1 N72?
by boneglove » Tue Oct 14, 2008 1:56 pm
I am using a Fluke 87 III dmm. When checking J1 of the N72, pins 1 to 2 I get OL, but not before. I was getting a low climbing 1.4 ish that wouldn't stop. Pins 3 and 2 I get 3.883 steady. Not really sure how the meter works yet. Have it set to middle ohms setting on the knob. Is this a good reading? I don'twant to power it till I check in. Thanks.
- boneglove
- Posts: 19
- Joined: Mon Jan 07, 2008 12:17 pm
by boneglove » Tue Oct 14, 2008 2:16 pm
Ok now I'm getting 1.490 climbing 1 at a time on pins 1 &2. I just bought this dmm used. Is there a factory reset or check to ensure it's proper operation?
On D11 J7 pins 1&2 1.835 climbing 1, 2&3 2.090 climbing. I have no idea what it should be.
On D11 J7 pins 1&2 1.835 climbing 1, 2&3 2.090 climbing. I have no idea what it should be.
- boneglove
- Posts: 19
- Joined: Mon Jan 07, 2008 12:17 pm
3 posts
• Page 1 of 1
Who is online
Users browsing this forum: No registered users and 2 guests