CH01 - B16 Panel Template
Posted: Fri Nov 11, 2022 5:04 pmHi All,
I have built 4x B16s and they are going into a CH01 chassis, so.... I decided to try printing out proper panel markings on a piece of printable plastic.
First run was done on Vinyl but I found it too stretchy and the ink scratched off VERY easily. Round 2 was printed on something less stretchy (I don't recall the material at the moment) and I put a clear layer on top. It does not stick down hard but the control nuts hold everything in place. All in all I think it will work well!
I will attache a picture and a PDF of the template (if I can get phpBB to cooperate!) for anyone who might find this usefull!
Thanks John
I have built 4x B16s and they are going into a CH01 chassis, so.... I decided to try printing out proper panel markings on a piece of printable plastic.
First run was done on Vinyl but I found it too stretchy and the ink scratched off VERY easily. Round 2 was printed on something less stretchy (I don't recall the material at the moment) and I put a clear layer on top. It does not stick down hard but the control nuts hold everything in place. All in all I think it will work well!
I will attache a picture and a PDF of the template (if I can get phpBB to cooperate!) for anyone who might find this usefull!
Thanks John