Seventh Circle Audio

I've just finished both an A12 and N72 module, which were both showing perfect voltage readings when tested seperately, and the chasis LED was at a steady ON when only 1 module was hooked up at a time.

Then I put both modules into the chasis, hooked them up to the PS, and now the LED only blinks, about once every 2 seconds.


Any ideas?

Have you tried connecting only one module at a time while installed in the chassis? Is one of the modules in the left-most position? If so, are you sure there are no shorts against the chassis divider due to improperly trimmed component leads?

That was it! Thanks, now the light it working fine.
I've got to get another XLR cable tomorrow before I can try it out, but so far things are looking good for my first electronics project.