The voltage at R8 is reading between 11.9 and 13.2 and jumping around a lot. (step 38)
The voltage between L3 and L4 is reading around 860mv and also jumping around a bit. (step 39)
What is the most likely cause of this?
When I first powered up the unit Q6 and Q9 were accidentally reversed. also R49 was the wrong value - 10k instead of 20k. I didn't notice it until after I powered up the unit and began to test voltages. I fixed those two problems, but fear I blew something out by powering up before checking my work...
Is it likely that I blew out a component?
Thanks