Hello,
I am trying to build the T15, the first of 4 that I ordered, and like the subject says I'm stuck on step 10, which reads:
"Add the 0.1” headers and shorting jumpers at J1 and J2. Install the headers with the long pins up! The jumpers connect pin 1 of CONN1 and CONN2 to ground as shown in the table above. Unless you encounter issues with ground loop hum, jumper pins 2 and 3 on both headers as shown at right. A jumper must be installed at J1 to complete the phantom power circuit."
First, I do not see J1 or J2 printed on my board. Judging from the picture in the instructions, I'm supposed to be putting something in-between CONN1 and CONN2, but on my board, that space says CONN4. Second, I don't seem to have the part in the picture included with my kit, although this might be because the picture is of low quality and I can't see it clearly. However, it looks as though that part would not fit in my "CONN4" slot regardless. Lastly, parts for J1, J2, and CONN4 are not listed on my bill of materials.
So what exactly am I supposed to do at this step? Am I missing a part(s), or just overlooking something?
I hope I was able to describe my problem/question clearly, as I am still fairly new to work like this.