Final reading off by a few volts

Post questions or comments about the T15 here.

Final reading off by a few volts

Postby creasetoph » Sun Jul 15, 2012 5:47 pm

For starters i have a rev 1.4 board w/ the new chassis.
So in the initial tests i get 18.2v at the +18v pad or at pin 7 of U1, but i get -15.4 at the -18v pad or at pin 4 of U1, all is respect to PGND. I have double checked every part and all the solder joints look fine. Is there anything else i can test to make troubleshooting easier? Thanks
creasetoph
 
Posts: 3
Joined: Sun Jul 15, 2012 5:26 pm

Postby creasetoph » Thu Jul 19, 2012 9:34 am

Well it seems everything has worked out, when i powered it on after a few days the measurements are 18.2v and -17.8v. I guess it just needed a little time to adjust.
creasetoph
 
Posts: 3
Joined: Sun Jul 15, 2012 5:26 pm


Return to T15

Who is online

Users browsing this forum: No registered users and 3 guests

cron